At the Connection Description window, enter a session name in the Name field. Refer to Figure 1 for a description of the opening HyperTerminal configuration window. Cisco hyperterm config windows#Task 2: Configure HyperTerminal to Establish a Console Session with a Cisco IOS Router.įrom the Windows taskbar, start the HyperTerminal program by clicking Start > Programs > Accessories > Communications > HyperTerminal.įigure 1. If not already powered on, enable power to the computer and router. Connect the other cable end to the host computer with a DB-9 or DB-25 adapter to the COM 1 port. Step 1: Set up basic physical connection.Ĭonnect the console (rollover) cable to the console port on the router. Task 1: Connect a Router and Computer with a Console Cable. Console (rollover) cable for connecting the workstation to the router. Cisco hyperterm config serial#Computer with a serial interface and HyperTerminal loaded.The following resources will be required: Any router that meets the interface requirements may be used. Set up a network similar to the one in the Topology Diagram. Lab 10.6.2 Establishing a Console Session with HyperTerminal Network Fundamentals: Planning and Cabling Networks Lab 11.5.6: Final Case Study - Datagram Analysis with Wireshark.Lab 11.5.5: Network Documentation with Utility Commands. Lab 11.5.3: Configure Host Computers for IP Networking.Lab 11.5.2: Managing Device Configuration.Lab 11.5.1: Basic Cisco Device Configuration.11.4.3.3: Network Latency Documentation with Ping.Lab 10.6.3: Establishing a Console Session with Minicom.Lab 10.6.2: Establishing a Console Session with HyperTerminal.Lab 10.6.1: Creating a Small Lab Topology.9.9.1: Skills Integration Challenge-Switched Ethernet.Lab 9.8.3: Intermediary Device as an End Device. Cisco hyperterm config mac#
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |